1. Foamiran blue
2. Punch 5 or 6 petals (diameter 1.5 cm)
3. Acrylic paint
4. Iron or curling iron.
5. Stacks for sculpting
6. Beading Wire 0.2mm
7. Teip Feed light green
From foamirana blue punch cut out flowers. Ideally, the punch needed to 5 petals, but suitable and 6. If the punch zazhevyvaet foamiran – you need to put under foamiran paper.
Skewer flowers on the needle.
Toning edge acrylic paint a lighter color (white today I took the silver, but it would be better with a light blue). Complete drying not wait until the flowers may stick together.
Next comes the heat treatment:
prick the needle flower, trays to the heat source. Once the flowers nestle on the edge curling, and middle, would be convex – move to the middle of a sponge and dent stack for modeling. Stack the left – get more open flower. Processed stack to the right, I like more.
Take the white acrylic paint, paint inside the brush №0 color five-pointed “star”. For colors with 6 petals (pictured left), “star” is also painted five-pointed.
Take beading wire, is placed on the wire bead zhelotogo colors (well, if transparent beads), a “tail” doing shorter, about 2 cm long second – 7-8 cm. Curl them.
Flowers sit down to the wire, wrapped with a flower stalk (about 1 cm) teip-tape.
1.Skruchivaem with two flowers (left), a junction close teip-tape (pictured right).
2.Tochno also connect with 3 flowers.
3.Soedinyaem them to the first two, the connection closes again teip tape.
4.Berem 3 more flower, twist, close the connection longer teip piece of tape. Do it for all the flowers were on the same level, ie. E. Form the inflorescence does not bunch, and an umbrella.
Repeat p.p.1- 4, and connect with our first sprig. Ie from smaller collect one large umbrellas.
Right inflorescence of 15 colors 6 petals. On the other two took 33 florets.
The inflorescence can be formed and smaller and larger, depending on the destination.
Leaflets I did not do. Sorry!
From 5-petal flowers.
From 6 petal flowers
Where some – not tell.