How to make paper dish for wall art
Glue of the needle of the needle 6.3.2
Craft packing paper
Cut into 2 cm wide
I took the tracing paper from under the shoes in the shoe boxes
I twist on a spoke 1.8 cm rolling with a rolling pin – this will be our braid
It is in large rings small rings width 2 cm length 6 cm twisted on the spoke 3 cm
I cut the paper around the circumference I want so that I have a ring
I wind the tip on the needle and glue all the paper with glue, preferably 2 cm, which will be wound directly on the spoke, do not miss it – it will be difficult to pull off the knitting needle
Here it is wound up, it is good to roll on a spoke so that it is pasted
Rolling a rolling pin
And glue in a ring of the right diameter
And fill it with a pattern, well, here’s what fantasy tells you
Inserting glass, you can have beads, who likes what
We braid the next ring and put on a ring filled with a pattern, preferably before the braid, when you measure the ring, make it 1 mm wider, and then it will be small – you will not put it on
like this
Well and to them, we make a skeleton
I make the ring a little bigger, taking into account that we will braid the frame
Made of these strips small pads in the form of triangles, to create a form of dish
Here on the side of the empty ringlet is seen a small tubercle – that’s what I put in order for the dish to take a concave shape Doing separately the elements of the pattern and dragging them to the frame
So skeleton and inserted circles
It remains to paste the bottom
Braid
These are small rings
I twist on a spoke 3
I twist into the rings on the spoke 6
Well, this bottom is attached to the dish
courtesy: liveinternet