Styrofoam cut out the core of our future baskets – a trapezoid with the parameters of the bottom 5 cm, the top of the top 7 cm, height 4.5 cm.
I took for the base tile for wall insulation. She called on the scientific Extruded polystyrene. Very nice to work with him, because it does not crumble and easy to cut. Looking ahead to say that as well as foam. melts from time. Therefore only we work with titanium or melting.
We give shape to our basket. To do this, cut off on the sides, giving a rounded shape.
That’s what should happen as a result.
Getting to the formation of the basket.
The bottom draping burlap, which is the glue using a Titan.
Small edge burlap folded onto the side parts.
With the help of Thermo fix the twine on the edge of the base.
To save time, the first two turns fix hot glue, then Titan.
And so gradually swathes of the entire base.
With twine Moment winding wire, leaving a 1 cm at the ends. It will handle our future baskets. I wire a total length of 22 cm.
Got two here are the parts that will be connected to each other.
To start a wire should be given the appropriate form of the handle.
PLANNED (Pierce) the place where the handle is attached.
Lubricate these places, Titan.
And inserted to the wire leaving to dry completely.
Now another important point. Perhaps it had to announce before the string winding, but I do it after winding (but before the handle locking).
So. It is necessary to make a recess in which it will be convenient to fix our decor in the form of flowers. To do this, make a recess in the 0.7-1 cm using stationery knife.
That is what happens as a result.
The last step is to mount the magnet. I fix it with hot melt glue. Important (!) To the gun was well warmed up, or a magnet through a time to unstick.
Our basket-ready base) is now a flight of fancy – to transgress decor. But about once a second time …